Config.snmp.addaccessentry - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

config
2

config.snmp.addAccessEntry

E/OS Command Line Interface User Manual
2-76
ATTENTION! Before enabling SNMPv3, ensure all desired communities are
configured for SNMPv3 access. If existing community strings are not
configured for SNMPv3, then existing SNMP access will be lost.
NOTE: The authentication/privacy key (password) configured for an
SNMPv3 User on a switch is not localized. Therefore, the
authentication/privacy key configured in the SNMP management
application must be configured as a non-localized authentication/privacy
key in ASCII format. For more information on localization, refer to
http://www.ietf.org/rfc/rfc3414.txt?number=3414.
Syntax
addAccessEntry index secModel secLevel groupName
Adds an entry to the Access Table.
Purpose
This command has four parameters:
Parameters
index
secModel
secLevel
groupName
Index of the access entry. Valid values are 1 to
12.
Specifies the Security Model to be used for this
entry. Possible values for this parameter are
v1, v2 and usm.
Specifies the security level for this entry. It
specifies whether the entry requires
authentication and/or privacy. The possible
values for this parameter are authPriv,
authNoPriv and noAuthNoPriv.
Specifies the Group Name for the particular
Access Table entry. The maximum length for
the group name is 32 characters and all
characters in ISO Latin 1 character set are
valid for the group name. Duplicate group
names are allowed as long as the groupName,
secModel, and secLevel for those entries can
specify a Unique Access Table Entry (At least
one field differs when the group name is the
same).