Show.opentrunking.reroutelog - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

show
2
Output Example

show.openTrunking.rerouteLog

Command Example
E/OS Command Line Interface User Manual
2-196
The output from the show.openTrunking.config command appears as
follows:
Unresolved Congestion:
Backpressure:
Low BB_Credit Threshold (%):
Port
----
1
2
3
4
5
...
Syntax
reroutelog [clear]
This command displays the Open Trunking Re-route Log
Purpose
information.
ATTENTION! If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the Open Trunking Re-route Log is lost.
This command has one optional parameter:
Parameters
clear
show opentrunking reroutelog
NOTE: The clear parameter also clears the log entries for your SAN
management application.
Threshold %
------------
60 (default)
69
60 (default)
60 (default)
90
This optional parameter causes all re-route log
entries to be cleared.
Enabled
Disabled
75 (default)