Config.snmp.showusertable - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

config.snmp.showUserTable

Syntax
Purpose
Parameters
Index:
Target IP:
UDP Port:
Community Name:
MP Model:
Security Name:
Security Model:
Security Level:
These are explained in the table below.
SNMPv3 State Indicates whether SNMPv3 is enabled or
disabled.
Index The index number.
Target IP The IP address of the trap recipient.
UDP Port The UDP port of the trap recipient.
Community The community name.
MP Model The Messaging Model.
Secuirty Name The security name (user name).
Security Model The security model.
Security Level The security level.
NOTE: The command
show.snmp.targetTable
that is same as that of this command.
showUserTable [index]
This command displays the users configured presently in the USM
table.
This command has no parameters.
1
172.19.16.169
162
public
SNMPv1
user1
V1
No Authentication and No Privacy
on page 22-224 has functionality
config
CLI Commands
2-91
2