Config.snmp.addtargetparams - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

config
2
Command Example

config.snmp.addTargetParams

E/OS Command Line Interface User Manual
2-78
This command has five parameters. Up to six community names and
Parameters
trap recipients may be defined as follows:
commIndex
commName
writeAuthorization
trapRecipient
udpPortNum
Root> config snmp addCommunity 1 CommunityName1 enabled
123.123.123.123 162
Syntax
addTargetParams index secName grpName model level
This command associates additional USM configuration values to the
Purpose
trap recipient. These values are required to perform the access control
validation before sending the trap messages. This command operates
on an entry created by one of addv1Target, addv2Target, or addv3Target
commands.
Specifies the community to be created or
edited. Valid values are integers in the range
1–6.
Specifies the community name of the
community specified by commIndex. The
community name must not exceed 32
characters in length. Valid characters include
all those in the ISO Latin-1 character set.
Duplicate community names are allowed,
but the corresponding writeAuthorization
values must match.
Specifies the write authorization state of the
community. Valid values are enable and
disable. Boolean 1 and 0 may be substituted as
values.
Specifies the IP address of the trap recipient.
Values must be 4 bytes in dotted-decimal
format.
Specifies the user datagram protocol (UDP)
port number to which the director sends
traps for each recipient. The value can be a
decimal number or default. The default value
is 162. Valid values include all legal UDP
port numbers.