perf
2
Command and
Output Examples
perf.preferredPath.showState
Command Example
perf.thresholdAlerts
E/OS Command Line Interface User Manual
2-144
The following examples show the output returned by the three
methods of specifying the perf.preferredPath.showPath command.
Single values for both parameters
Root> perf preferredPath showPath 21 10
Preferred Path State: Enabled
Preferred Exit Port:
destDomainId set to all
Root> perf preferredPath showPath all 15
Preferred Path State: Enabled
Destination Domain
------------------
1
3
4
17
sourcePort set to all
Root> perf preferredPath showPath 1 all
Preferred Path State: Enabled
Source Port
------------------
0
2
3
22
Syntax
showState
This command shows the enabled state for preferred path
Purpose
This command has no parameters.
Parameters
Root> Perf PreferredPath showState
The perf.thresholdAlerts commands enable you to configure alerts that
notify you of specific conditions on your system.
Not Configured
Preferred Exit Port
-------------------
23
24
23
12
Preferred Exit Port
-------------------
2
5
17
5