Parameters
Command Example
Output
Output Example
Port
Xvr
Temp
----
---
----- --------
0
UNK
UnknownUnknownUnknownUnknown
1
UNK
UnknownUnknownUnknownUnknown
2
UNK
UnknownUnknownUnknownUnknown
3
UNK
UnknownUnknownUnknownUnknown
4
XFP
36.1053.2565.324
show.port.opticHealth
Syntax
Purpose
This command has no parameters.
Show port opticEDD
The port optic diagnostic data is displayed as a table that includes the
following properties.
Port
Xcvr
Temp
3.3 Voltage
Current
TX Pwr
RX Pwr
1.8 Voltage
5.0 Voltage
The show.port.opticEDD command output appears as follows:
3.3 VoltCurrent TX Power
-------
602.100
opticHealth
This command shows the overall optic health for all ports that
support Enhanced Digital Diagnostics (EDD).
NOTE: At unit startup, the health of the optics will be read at roughly one
optic per second, and once it reaches the last port, it start from the beginning
and update any changes.
The port number.
The transceiver type.
The optic temperature in celsius.
The 3.3 voltage in volts.
The current in mA.
The transceiver power in uW.
The receiver power in uW.
The 1.8 voltage in volts.
The 5.0 voltage in volts.
RX Power1.8 Volt5.0 Volt
--------- -----------------
Unknown
UnknownUnknown
Unknown
UnknownUnknown
Unknown
UnknownUnknown
Unknown
UnknownUnknown
289.3001.7794.998
show
-------
CLI Commands
2-205
2