Config.snmp.addv1Target - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual

config
2
Index Username
----- --------------------------------
1 smith
2 smith
3 smith

config.snmp.addV1Target

Command Example
E/OS Command Line Interface User Manual
2-82
Syntax
addV1Target index community [IP] [udpNum]
This command configures a v1 community string. The IP address and
Purpose
port number of a v1 trap recipient can be optionally specified. The
community string can be used for v1 access only if mapped to a
security and group name.
This command has four parameters. The last two are optional.
Parameters
index
community
IP
udpNum
Root> config snmp addv1target 4 joe 125.26.78.95 162
Model Group Name
----- ----------
V1 smithGroup
USM smithGroup
USM smithOtherGroup
Index of the Target entry. Valid values are 1 to
6.
Community string of the Target entry. The
maximum length of the Community string is
32 characters. All characters in the ISO Latin-1
character set are valid for community names.
Duplicate community names are allowed, but
the corresponding security names (refer to the
command
config.snmp.addTargetParams
page 22-78) must also match.
The address of the trap recipient shown in
4-byte dotted-decimal format.
The UDP Port Number of the Trap recipient,
to which the SNMP agent will send the traps.
This value is expressed in decimal and the
default value is 162.
The default number is assumed if this field is
replaced with default. All legal UDP port
numbers are allowed. If the IP address is
specified and this parameter is not specified, it
will be set to the default value.
on