Config.snmp.setfamibversion; Config.snmp.setstate - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual
Fw 08.01.00 mcdata e/os command line interface user manual (620-000134-740, november 2005)
Hide thumbs
Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
- Manual (684 pages) ,
- Installation and service manual (612 pages) ,
- User manual (312 pages)
Table of Contents
Advertisement
Parameters
Command Example
config.snmp.setFaMibVersion
Syntax
Purpose
Parameters
Command Example
config.snmp.setState
Syntax
Purpose
Parameters
Command Example
This command has one parameter:
enabledState
Enabled state of SNMPv3. This can be set to
enable or disable. Boolean 1 and 0 values may
also be substituted.
Root> config snmp setSNMPv3State enable
setFaMibVersion versionNumber
This command sets the version of the Fibre Alliance MIB with which
the SNMP agent interacts. The version number can be set to 3.0 or 3.1.
This command has one parameter:
versionNumber
Sets the version of the Fibre Alliance MIB
version number. Accepted values for this
command are 3.0 or 3.1.
Root> config snmp setFaMibVersion 3.1
setState enabledState
This command enables or disables the SNMP agent. When disabled,
the SNMP agent does not respond to any requests or send any traps.
This command has one parameter:
enabledState
Sets the state of the SNMP agent. This
parameter can be set to enable or disable.
Boolean 1 and 0 values may also be
substituted.
Root> config snmp setState 1
config
CLI Commands
2-87
2
Advertisement
Table of Contents
