McDATA 316095-B21 - StorageWorks Edge Switch 2/24 User Manual page 187

This command has the following parameters:
Parameters
destDomainId
sourcePort
The output from the perf.preferredPath.showPath command includes
Output
the following parameters:
Destination
Domain
Source Port
Preferred Exit
Port
Specifies the destination domain ID. Valid
domain IDs are in the range 1–31 or all, which
shows all paths to and from the source port
specified in the sourcePort parameter.
Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–31 for the ED-5000
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
Or, you can specify all to show all paths to the
destination domain ID specified for the
destDomainId parameter.
The destination domain ID for which a
preferred path has been configured. This is
displayed only if the destination domain
parameter is set to all.
This is the source port for which a preferred
path to the specified destination domain ID is
specified. This is displayed only if the source
port parameter is set to all.
The configured preferred path exit port. This
value can be any port number, or blank to
indicate that no preferred path has been
configured.
perf
CLI Commands
2-143
2