Connecting The Srx210 Services Gateway To Management Devices; Connecting An Srx210 Services Gateway To The J-Web Interface - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

CHAPTER 15
Connecting the SRX210 Services Gateway
to Management Devices

Connecting an SRX210 Services Gateway to the J-Web Interface

Copyright © 2010, Juniper Networks, Inc.
This chapter includes the following topics:
Connecting an SRX210 Services Gateway to the J-Web Interface on page 89
Connecting an SRX210 Services Gateway to the CLI Locally on page 91
Connecting an SRX210 Services Gateway to the CLI Remotely on page 93
Connecting the Modem at the SRX210 Services Gateway End on page 93
Connecting the Modem to the Console Port on the SRX210 Services Gateway on page 94
Connecting to the CLI at the User End for the SRX210 Services Gateway on page 95
If you plan to use the J-Web interface to configure the SRX210 Services Gateway, you
must connect through one of the built-in Ethernet management ports.
When the services gateway is powered on for the first time, the system looks for a DHCP
server. If it does not find one, the system assigns an IP address within the
subnetwork to any devices connected to the system.
To connect to the J-Web interface through any of the ports
on the services gateway, see Figure 27 on page 90.
fe-0/0/7
192.168.1.0/24
ge-0/0/1 or fe-0/0/2 to
89