Adjusting The Power Supply Adapter Tray For The Srx210 Services Gateway For Rack-Mount Installation - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide
Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for Rack-Mount
Installation
70
Install the device as appropriate for your site using one of the following procedures:
Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for
Rack-Mount Installation on page 70
Installing the SRX210 Services Gateway in a Rack on page 71
Installing the SRX210 Services Gateway on a Desk on page 74
Installing the SRX210 Services Gateway on a Wall on page 76
This topic provides details on the power supply adapters provided with different models
of the SRX210 Services Gateway and the procedure for adjusting the power supply
adapter tray to hold the power supply adapter.
The following power supply adapters are provided with the SRX210 Services Gateway:
60-watt power supply adapter for the SRX210 Services Gateway Low Memory and
High Memory models
150-watt power supply adapter for the SRX210 Services Gateway with PoE and the
SRX210 Services Gateway with Integrated Convergence Services
To adjust the power supply adapter tray:
To accommodate the 60-watt power supply, use the two 420–028535 screws to
attach the adapter stopper brackets at the point on the chassis marked B.
Figure 15 on page 70 shows the adjustments to the power supply adapter tray required
for the 60-watt power supply.
Figure 15: Adjusting the Power Supply Adapter Tray to Accommodate the
60-Watt Power Supply
Location for the adapter stopper brackets in the power supply adapter tray
1.
Fully configured power supply adapter tray
2.
To accommodate the 150-watt power supply, use the 420–028535 screw to attach
the adapter stopper bracket at the point on the chassis marked A.
Copyright © 2010, Juniper Networks, Inc.