Srx210 Services Gateway Boot Devices And Dual-Root Partitioning Scheme; Boot Devices - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide
Related
Documentation

SRX210 Services Gateway Boot Devices and Dual-Root Partitioning Scheme

Boot Devices

22
Table 13: SRX210 Services Gateway Voice Interface Port LEDs
LED Color
Voice Interface Off
LEDs
Green
(FXS1, FXS2, FXO1,
and FXO2)
Amber
Green
Red
Red
SRX210 Services Gateway Specifications on page 7
SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 10
SRX210 Services Gateway with Integrated Convergence Services Front Panel and Back
Panel Views on page 12
SRX210 Services Gateway Built-In Interfaces on page 14
SRX210 Services Gateway Boot Devices and Dual-Root Partitioning Scheme on page 22
SRX210 Services Gateway Cooling System on page 23
SRX210 Services Gateway Power Supply on page 25
This topic includes the following sections:
Boot Devices on page 22
Dual-Root Partitioning Scheme on page 23
The SRX210 Services Gateway can boot from two devices:
Internal NAND flash (default; always present)
USB storage key (alternate)
State Description
Unlit Port is inactive.
Steady Port is connected and active.
Steady Port is active, but not ready for
data communication.
Blinking Port is active and data
communication is taking place.
Blinking Port is initializing.
NOTE: The Voice Interface
port LEDs glow red (blinking)
while initializing. If there is an
error, the LEDs remain red;
otherwise, change to green.
Steady Port has detected a hardware
initialization failure.
Copyright © 2010, Juniper Networks, Inc.