Configuring Basic System Properties - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide

Configuring Basic System Properties

104
Access the J-Web interface:
4.
Launch a Web browser from the management device.
a.
Enter 192.168.1.1 in the Address box.
b.
Specify the default user name as root. Do not enter any value in the Password box.
c.
Press Enter. The J-Web Setup Wizard page opens.
d.
Use the wizard to configure the basic settings, such as Hostname, Domain Name, and
5.
Root Password, for your services gateway.
The upper left area of the wizard page shows where you are in the setup process. Click
a field in the wizard page to display information about that field in the lower left area
of the page.
You can also use the wizard to configure the following settings:
Default gateway
DNS servers
Domain search
VLANs
Interfaces
NOTE: All network and management access settings are optional.
See Table 39 on page 105 Table 40 on page 105 summarize the configuration
details for the initial setup.
Click Commit on the Review & Commit page to apply the configuration.
6.
NOTE: After you configure the basic settings, the J-Web Setup wizard
redirects you to the J-Web pages where you can continue working in the
J-Web interface.
Table 39 on page 105 and Table 40 on page 105 summarizes the configuration details for
initial setup.
Copyright © 2010, Juniper Networks, Inc.