Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual page 34

SRX210 Services Gateway Hardware Guide
16
Table 10: SRX210 Services Gateway Built-In Hardware
Interfaces (continued)
Interface Type
Universal Serial Bus (USB)
Console
Specifications
Consist of two ports
Function in full speed and
high speed
Are compliant with USB
revision 2.0
Consists of one port
Uses an RJ-45 serial cable
connector
Supports the RS-232
(EIA-232) standard
Copyright © 2010, Juniper Networks, Inc.
Description
The USB ports can be used as
follows:
To support a USB storage
device that functions as a
secondary boot device in
case of the internal flash
failure on startup, if the USB
storage device is installed
and configured
NOTE: You must install and
configure the USB storage
device on the USB port to use
it as secondary boot device.
Also, the USB device must
have Junos installed.
To provide the USB
interfaces that are used to
communicate with many
types of Juniper supported
USB storage devices.
Contact your Juniper Networks
customer service
representative for more
information.
The console port can be used
as follows:
To provide the console
interface
To function as a
management port to log
into a device directly
To configure the device
using the CLI