Performing Initial Software Configuration On The Srx210 Services Gateway Using The J-Web Interface; Establishing Basic Connectivity - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

Related
Documentation
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface

Establishing Basic Connectivity

Copyright © 2010, Juniper Networks, Inc.
Chapter 16: Performing Initial Software Configuration on the SRX210 Services Gateway
admin@host# exit
admin@host>
Connecting an SRX210 Services Gateway to the CLI Locally on page 91
Connecting an SRX210 Services Gateway to the CLI Remotely on page 93
SRX210 Services Gateway Software Configuration Overview on page 97
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface on page 103
SRX210 Services Gateway Secure Web Access Overview on page 106
This topic includes the following sections:
Establishing Basic Connectivity on page 103
Configuring Basic System Properties on page 104
To establish basic connectivity:
Connect an Ethernet cable from any of the
1.
the Ethernet port on the management device (workstation or laptop).
Connect the power cable to the device and a power source. (We recommend using
2.
a surge protector.) Note the following indications:
Power LED (steadily green): The device is receiving power.
Status LED (steadily green): The device is operating normally.
NOTE: The services gateway functions as a DHCP server and will assign
an IP address to the management device.
Ensure that the management device acquires an IP address on the 192.168.1.0/24
3.
subnetwork (other than 192.168.1.1) from the device.
NOTE: If an IP address is not assigned to the management device,
manually configure an IP address in the 192.168.1.0/24 subnetwork. Do
not assign the 192.168.1.1 IP address to the management device, as this IP
address is assigned to the services gateway.
ge-0/0/1 or fe-0/0/2 to fe-0/0/7 ports to
103