Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual page 90

SRX210 Services Gateway Hardware Guide
72
To install the device in a rack:
Position a mounting bracket on each side of the chassis as shown in Figure 17 on
1.
page 72.
Figure 17: Installation of SRX210 Services Gateway in a Rack — Positioning
Mounting Brackets
Table 31 on page 72 lists the parts used for installing the SRX210 Services Gateway
on the rack. The numbers in Figure 17 on page 72 correspond to the numbers in Table
31 on page 72.
Table 31: SRX210 Services Gateway Rack Installation Parts
Number Part
1 Mounting brackets
2 Screws (mounting bracket)
3 Power supply adapter tray
4 Adapter stopper bracket
Use a number-1 Phillips screwdriver to install the screws that secure the mounting
2.
brackets and power supply adapter tray to the chassis as shown in Figure 18 on page 72.
Figure 18: SRX210 Services Gateway Rack Installation — Securing
Mounting Brackets and Power Supply Adapter Tray
Place the power supply adapter in the tray as shown in Figure 19 on page 73.
3.
Copyright © 2010, Juniper Networks, Inc.