Pinouts; Interface Cable And Wire Specifications For The Srx210 Services Gateway - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

APPENDIX C
SRX210 Services Gateway Interface Cable
Specifications and Connector Pinouts

Interface Cable and Wire Specifications for the SRX210 Services Gateway

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
The network interfaces supported on the services gateway accept different types of
network cables.
This appendix includes the following topics:
Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 155
RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port on page 156
RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port on page 157
RJ-11 Connector Pinouts for the SRX210 Services Gateway with Integrated Convergence
Services FXO and FXS Ports on page 158
Table 48 on page 155 lists the specifications for the cables that connect to ports.
Table 48: Cable and Wire Specifications for Ports
Port Cable Specification
Console RS-232 (EIA-232) serial
port cable
Ethernet CAT-5e (Category 5)
port cable or equivalent
suitable for 100BASE-T
operation
RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port on page 156
RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port on page 157
SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 10
Maximum
Cable/Wire Required Length
One 6-ft (1.83-m) length 6 ft (1.83 m)
with DB-9/RJ-45
connectors
One 15-ft (4.57-m) 328 ft
length with RJ-45/RJ-45 (100 m)
connectors
Device
Receptacle
RJ-45
RJ-45
155