Connecting To The Cli At The User End For The Srx210 Services Gateway; Connecting The Modem At The Srx210 Services Gateway End - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

Related
Documentation

Connecting to the CLI at the User End for the SRX210 Services Gateway

Copyright © 2010, Juniper Networks, Inc.
Chapter 15: Connecting the SRX210 Services Gateway to Management Devices
Turn on the power to the modem.
8.
Power on the services gateway by pressing the Power button on the front panel. Verify
9.
that the LED on the front panel turns green.
Power
NOTE: Most modems have an RS-232 DB-25 connector. You must
separately purchase an adapter to connect your modem to the RJ-45 to
DB-9 adapter and the Ethernet cable supplied with the services gateway.
Connecting the Modem at the SRX210 Services Gateway End on page 93
Connecting to the CLI at the User End for the SRX210 Services Gateway on page 95
SRX210 Services Gateway Software Configuration Overview on page 97
To remotely connect to the CLI through a dial-up modem connected to the console port
on the services gateway:
Connect a modem at your remote location to a management device such as a PC or
1.
laptop computer.
Start your asynchronous terminal emulation application (such as Microsoft Windows
2.
HyperTerminal) on the PC or laptop computer.
Select the port to which the modem is connected (for example,
3. COM
Configure the port settings shown in Table 36 on page 95.
4.
Table 36: Port Settings for Connecting to the CLI at User End
Port Setting
Bits per second
Data bits
Parity
Stop bits
Flow control
In the HyperTerminal window, enter
5.
For more information on the AT commands, see the Junos OS Administration Guide.
An OK response verifies that the modem can communicate successfully with the
port on the PC or laptop.
Value
9600
8
None
1
None
.
AT
).
COM1
COM
95