Gateway; Connecting, Grounding, And Powering On The Srx210 Services; Connecting The Srx210 Services Gateway To The Power Supply; Connecting And Organizing Interface Cables For The Srx210 Services - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

CHAPTER 13
Connecting, Grounding, and Powering On
the SRX210 Services Gateway

Connecting the SRX210 Services Gateway to the Power Supply

Copyright © 2010, Juniper Networks, Inc.
This chapter includes the following topics:
Connecting the SRX210 Services Gateway to the Power Supply on page 79

Connecting and Organizing Interface Cables for the SRX210 Services

Gateway on page 80
Grounding the SRX210 Services Gateway on page 82
Powering On and Powering Off the SRX210 Services Gateway on page 83
To connect the device to the power supply:
CAUTION: Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your bare
wrist.
NOTE: If you are installing your services gateway on a desk, ensure that your
device is adequately grounded using the grounding point on the back panel
of the chassis.
Plug the DC connector end of the power cable into the power connector on the back
1.
of the device (see Figure 25 on page 80).
Plug the AC adapter end of the power cable into an AC power outlet.
2.
79