Connecting The Srx240 Services Gateway To Management Devices; Connecting To The Srx240 Services Gateway Setup Wizard - Juniper SRX240 Hardware Manual

CHAPTER 12
Connecting the SRX240 Services Gateway
to Management Devices

Connecting to the SRX240 Services Gateway Setup Wizard

Copyright © 2013, Juniper Networks, Inc.
This chapter includes the following topics:
Connecting to the SRX240 Services Gateway Setup Wizard on page 63
Connecting the SRX240 Services Gateway to the CLI on page 64
Connecting the Modem at the SRX240 Services Gateway End on page 67
Connecting the Modem to the Console Port on the SRX240 Services
Gateway on page 68
Connecting to the CLI at the User End for the SRX240 Services Gateway on page 69
If you plan to use the setup wizard to configure the services gateway, you must connect
through one of the built-in Gigabit Ethernet ports. You can use any built-in Ethernet port
except port 0/0.
To enable communication between the management device and the services gateway,
ports 0/1 through 0/15 are preconfigured with the IP address
assign an IP address on the
To connect to the Ethernet port:
Ensure that the IP address for the Ethernet port on the management device is
1.
configured in one of the following ways:
The IP address is assigned by DHCP.
The IP address is on the
Turn off the management device.
2.
Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management
3.
device.
Connect the other end of the Ethernet cable to the built-in Gigabit Ethernet port (any
4.
one port between 0/1 and 0/15) on the services gateway as shown in
Figure 17 on page 64.
network to any connected device.
192.168.1.0/24
subnetwork (but is not
192.168.1.0/24
192.168.1.1 . DHCP is used to
).
192.168.1.1
63