Preparing The Srx210 Services Gateway For Wall-Mount Installation - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide

Preparing the SRX210 Services Gateway for Wall-Mount Installation

Related
Documentation
68
You can mount an SRX210 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Table 30 on page 68 provides the list of tasks you need to perform before installing the
device.
Table 30: SRX210 Services Gateway Preinstallation Checklist for
Wall-Mount Installation
Task
Verify that the site meets the requirements.
Remove the services gateway chassis from the
shipping carton.
Verify that you have the following parts available in
your wall-mounting kit to mount the SRX210 Services
Gateway on wall:
Wall-mounting brackets
Screws
NOTE: The wall-mounting kit is not shipped with the device and must be
ordered separately.
Site Preparation Checklist for the SRX210 Services Gateway on page 49
Unpacking the SRX210 Services Gateway on page 61
Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 65
Preparing the SRX210 Services Gateway for Desk-Mount Installation on page 67
Additional Information
"Site Preparation Checklist for the
SRX210 Services Gateway" on page 49
"Unpacking the SRX210 Services
Gateway" on page 61
Copyright © 2010, Juniper Networks, Inc.