Srx210 Services Gateway Mini-Physical Interface Modules - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

CHAPTER 6
SRX210 Services Gateway Mini-Physical
Interface Modules

SRX210 Services Gateway Mini-Physical Interface Modules

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
This chapter includes the following topic:
SRX210 Services Gateway Mini-Physical Interface Modules on page 45
The SRX210 Services Gateway supports Mini-Physical Interface Modules (Mini-PIMs).
A Mini-PIM is a network interface card (NIC) that is installed on the services gateway to
provide physical connections to a LAN or a WAN. The Mini-PIM receives incoming packets
from the network and transmits outgoing packets to the network. The Mini-PIMs supported
on the services gateway are field-replaceable. The field replaceable Mini-PIMs are
removable and insertable into the device. You can install a Mini-PIM into the Mini-PIM
slot available on the front panel of the services gateway chassis.
For more information about supported Mini-PIMs, including how to install and configure
Mini-PIMs, refer to the SRX Series Services Gateways for the Branch Physical Interface
Modules Hardware Guide.
CAUTION: The Mini-PIMs available on the SRX210 Services Gateway are not
hot-swappable. You need to power off the device before removing or installing
Mini-PIMs.
SRX210 Services Gateway Description on page 3
SRX210 Services Gateway Specifications on page 7
SRX210 Services Gateway Hardware Features on page 4
SRX210 Services Gateway Built-In Interfaces on page 14
45