Installing The 3G Expresscard In The Srx210 Services Gateway Expresscard; Slot - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide
Installing the 3G ExpressCard in the SRX210 Services Gateway ExpressCard Slot
32
Installing the 3G ExpressCard in the SRX210 Services Gateway ExpressCard Slot on
page 32
SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 10
TIP: Placing the SRX210 Services Gateway on a flat, level surface, with the
Juniper Networks logo facing up, will make it easier to align and insert the 3G
ExpressCard in the ExpressCard slot.
CAUTION: 3G ExpressCard is not hot-swappable on the SRX210 Services
Gateway.
To install the 3G ExpressCard in the ExpressCard slot on the SRX210 Services Gateway:
Align the 3G ExpressCard as follows:
1.
Ensure that the 3G ExpressCard is parallel with the surface on which the SRX210
Services Gateway is placed.
Ensure that the center of the 3G ExpressCard is aligned with the center of the
ExpressCard slot on the SRX210 Services Gateway.
Study Figure 14 on page 32, which shows installation of the 3G ExpressCard on the
2.
SRX210 Services Gateway.
Figure 14: Installing 3G ExpressCard in the SRX210 Services Gateway
Insert the 3G ExpressCard slowly and firmly into the ExpressCard slot until the 3G
3.
ExpressCard is engaged in the slot as follows:
The 3G ExpressCard is designed to fit tightly in the slot. You will encounter two
points of resistance while inserting the 3G ExpressCard into the slot. Use firm
pressure as you insert the card.
Copyright © 2010, Juniper Networks, Inc.