Monitoring The Srx210 Services Gateway Using Chassis Alarm - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Table 42: Component LEDs on the Services Gateway (continued)
LED State
HA LED Off
Mini-PIM LED Green
Off
Voice Interface Off
LED
Green (Steady)
Amber
Green (Blinking)
Red (blinking)
Red (steady)
Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 113
Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 118
Monitoring the SRX210 Services Gateway Power System on page 119
Using the Reset Config Button on the SRX210 Services Gateway on page 121
Changing the Reset Config Button Behavior on the SRX210 Services Gateway on page 121
Juniper Networks Technical Assistance Center on page 122
Chapter 18: Monitoring the SRX210 Services Gateway
Meaning
The Mini-PIM is present and
detected by the device.
The Mini-PIM is not present
or is not detected by the
device.
The port is inactive.
The port is active and
functioning normally.
The port is active and not
ready for data
communication.
The port is active and data
communication is taking
place.
The port is initializing.
NOTE: The Voice Interface
port LED glows red (blinking)
while initializing. If there is an
error, the LED remains red;
otherwise, the LED changes
to green.
The Port has detected a
hardware initialization failure.
Possible Causes and
Corrective Actions
The device is not part of the
chassis cluster setup.
Normal condition. No action
is required.
See "Monitoring the SRX210
Services Gateway Using
Chassis Alarm Conditions"
on page 118.
Normal condition. No action
is required.
Normal condition. No action
is required.
Normal condition. No action
is required.
Normal condition. No action
is required.
Normal condition. No action
is required.
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See "Juniper Networks
Technical Assistance
Center" on page 122.
117