Inaccessible - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide
Related
Documentation
Resetting the Configuration File When the SRX210 Services Gateway Is Inaccessible
120
Table 44 on page 120 describes different Power LED status settings and their corrective
actions.
Table 44: Services Gateway Power LED Status
LED Status
Green
Amber
Off
Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 113
Monitoring the SRX210 Services Gateway Components Using LEDs on page 115
Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 118
Using the Reset Config Button on the SRX210 Services Gateway on page 121
Changing the Reset Config Button Behavior on the SRX210 Services Gateway on page 121
Juniper Networks Technical Assistance Center on page 122
You can use the SRX210 Services Gateway's Reset Config button to restore the device's
configuration file when the current one is faulty or fails. You can also change the default
behavior of the Reset Config button.
Possible Cause and Corrective
Meaning Action
The device is receiving Normal indication. No action is required.
power, and the internal
power supply is functional.
The Power button has Normal indication. No action is required.
been pressed and quickly
released. The device is
shutting down or starting
up.
The device is not receiving
power.
Verify that the AC power cord from
the power source to the device is not
damaged. If the insulation is cracked
or broken, immediately replace the
cord or cable.
Ensure that the socket you plug in is
in working condition.
Ensure the device has an AC input
voltage between 110 and 240 VAC.
If you cannot determine the cause
of the problem or need additional
assistance, contact the Juniper
Networks Technical Assistance
Center (JTAC). See "Juniper
Networks Technical Assistance
Center" on page 122.
Copyright © 2010, Juniper Networks, Inc.