Connecting An Srx210 Services Gateway To The Cli Locally - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

Related
Documentation

Connecting an SRX210 Services Gateway to the CLI Locally

Copyright © 2010, Juniper Networks, Inc.
Chapter 15: Connecting the SRX210 Services Gateway to Management Devices
From the management device, open a Web browser and enter the IP address
6.
in the address field if the management device is configured using the DHCP.
Configure basic settings for your services gateway.
7.
NOTE: You must manually configure the IP address for the management
port you are using before you save your initial configuration. When you
save the configuration for the first time, you will lose the connection to
the services gateway if you have not manually configured the IP address.
If you lose the connection through the management interface, you must
connect through the console port.
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface on page 103
Connecting an SRX210 Services Gateway to the CLI Locally on page 91
SRX210 Services Gateway Software Configuration Overview on page 97
SRX210 Services Gateway Secure Web Access Overview on page 106
If you plan to use the CLI to configure the SRX210 Services Gateway, you must connect
through the console port, as shown in Figure 28 on page 91.
Figure 28: Connecting to the Console Port on an SRX210 Services Gateway
192.168.1.1
91