Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual page 108

SRX210 Services Gateway Hardware Guide
90
Figure 27: Connecting to the Ethernet Port on an SRX210 Services Gateway
To connect to the Ethernet port:
From the management device you use to access the J-Web interface (such as a PC
1.
or a laptop), verify that the address of the port you connect to is set to one of the
following values:
Ethernet address on the
Ethernet address from a DHCP server
Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management
2.
device.
Connect the other end of the Ethernet cable to any of the built-in Ethernet ports
3.
or to
ge-0/0/1 fe-0/0/2
Wait until the Status LED on the front panel of the services gateway turns steady
4.
green.
Turn on the power to the management device. The services gateway assigns an IP
5.
address to the management device within the
management device is configured to use DHCP.
NOTE: After connecting the management device to the services gateway,
the DHCP server process on the services gateway will assign an IP address
automatically to the management device. Ensure that the management
device acquires an IP address on the 192.168.1.0/24 subnetwork (other
than 192.168.1.1) from the device.
subnetwork other than
192.168.1.0/24
on the services gateway.
fe-0/0/7
192.168.1.0/24
192.168.1.1
subnetwork if the
Copyright © 2010, Juniper Networks, Inc.