Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual page 91

Copyright © 2010, Juniper Networks, Inc.
Figure 19: SRX210 Services Gateway Rack Installation — Positioning Power
Supply Adapter Tray
Have one person grasp the sides of the device, lift it, and position it in the rack.
4.
Align the bottom hole in each mounting bracket with a hole in each rack rail as shown
5.
in Figure 20 on page 73, making sure the chassis is level.
Figure 20: SRX210 Services Gateway Rack Installation — Hanging the
Services Gateway in a Rack
Have a second person install a mounting screw into each of the two aligned holes.
6.
Use a number-3 Phillips screwdriver to tighten the screws.
Install the second screw in each mounting bracket.
7.
Verify that the mounting screws on one side of the rack are aligned with the mounting
8.
screws on the opposite side and that the device is level.
Chapter 12: Installing the SRX210 Services Gateway
73