Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual page 110

SRX210 Services Gateway Hardware Guide
92
NOTE: Figure 28 on page 91 shows a connection to a local management
device. A remote connection to the services gateway through a modem
requires the cable and connector shown (provided in the services gateway
accessory box), plus a DB-9 female to DB-25 male (or similar) adapter for
your modem, which you must purchase separately.
To connect to the CLI using a local management device through the console port on the
services gateway:
Turn off power to the services gateway.
1.
Turn off power to the management device, such as a PC or laptop computer, that you
2.
are using to access the CLI.
Plug one end of the Ethernet cable supplied with your services gateway into the RJ-45
3.
to DB-9 serial port adapter supplied with your services gateway (see Figure 28 on
page 91).
Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management
4.
device (see Figure 28 on page 91).
Connect the other end of the Ethernet cable to the console port on the services
5.
gateway (see Figure 28 on page 91).
Turn on the power to the management device.
6.
Start your asynchronous terminal emulation application (such as Microsoft Windows
7.
HyperTerminal) and select the appropriate
Configure the port settings shown in Table 34 on page 92.
8.
Table 34: Port Settings for Connecting to the Console Port
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
Power on the services gateway by pressing the Power button on the front panel.
9.
Verify that the Power LED on the front panel turns green.
10.
The terminal emulation screen on your management device displays the startup
sequence. When the services gateway has finished starting up, a login prompt appears.
Log in as the user . No password is required at initial connection, but you must
11. root
assign a root password before committing any configuration settings.
port to use (for example,
COM
Value
9600
8
None
1
None
Copyright © 2010, Juniper Networks, Inc.
).
COM1