Understanding Built-In Ethernet Ports; Mapping The Chassis Cluster Ports - Juniper SRX210 - HARDWARE GUIDE REV 3 Hardware Manual

SRX210 Services Gateway Hardware Guide

Understanding Built-In Ethernet Ports

Mapping the Chassis Cluster Ports

98
NOTE: The SRX210 services gateway that ship with Junos OS Release 10.0
or later are formatted with dual-root partitions from the factory. SRX Series
devices that are running Junos OS Release 9.6 or earlier can be formatted
with dual-root partitions when they are upgraded to Junos OS Release 10.0
or later.
For more information on dual-root partitioning, see the Junos OS Administration Guide.
You configure the services gateway by issuing Junos OS command-line interface (CLI)
commands.
Gather the following information before configuring the device:
Device name to be used on the network
Domain name the device will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
Note the following points about the SRX210 Services Gateway management port:
The SRX210 Services Gateway uses
management ports to perform initial device setup. Before initial configuration, when
the factory default configuration is active, the device attempts to perform
autoinstallation by obtaining a device configuration through all of its connected
interfaces.
The services gateway acts as a DHCP client on the port
and to
ge-0/0/1 fe-0/0/2
192.168.1.1/24. With the device temporarily acting as a DHCP server, you can manually
configure it with the J-Web interface.
Any DHCP client host, for example, a PC or laptop computer, that is directly connected
to any of or
ge-0/0/1 fe-0/0/2
192.168.1.0/24 network.
On the SRX210 Services Gateway, the
gateway is operating in chassis cluster mode.
The port is dedicated as the out-of-band management interface for each of the
fxp0
devices in the chassis cluster setup and the
control port.
and
ge-0/0/1 fe-0/0/2
act as a DHCP server and assign the IP address as
fe-0/0/7
to ports receives an address on the
fe-0/0/7
fxp1 port is not user-configurable when the services
fxp1 port is dedicated as the chassis-cluster
to as a
fe-0/0/7
ge-0/0/0 , and the ports
Copyright © 2010, Juniper Networks, Inc.