Installing Memory Unit Type C (Sdram Module) - Ricoh CL1000N User Manual

Ricoh cl1000n: user guide

Hide thumbs Also See for CL1000N:

Table of Contents

Installing Memory Unit Type C (SDRAM Module)

• Do not touch the inside of the

controller board compartment. It

may cause a machine malfunc-

tion or a burn.

❒ Before touching the memory unit,

touch something metal to dis-

charge any static electricity. Static

electricity can damage the memory

❒ Do not subject the memory unit to

physical shocks.

❒ If a hard disk drive is already at-

tached, temporarily remove it and

insert the SDRAM module. After

inserting the SDRAM module, re-

install the hard disk drive.

Turn off the power, and then un-

plug the power cable.

Loosen the two screws securing

the controller board using the

screwdriver provided.

❒ The screws cannot be fully re-

Remove the controller board hold-

ing the two screws loosened in

Place the controller board on a flat

The memory unit is installed in

the slot shown in the illustration

Table of Contents