Memory Unit Type C (Sdram Module) - Ricoh AP400 Setup Manual

Installing Options

Memory Unit Type C (SDRAM Module)

Important
❒ Before touching the Memory Unit,
touch something metal to dis-
charge any static electricity. Static
2
electricity can damage the Memo-
ry Unit.
❒ Do not subject the Memory unit to
physical shocks.
A A A A
Check the contents of the box for
the following items:
• Memory Unit
• Installation Guide
B B B B
Confirm that the followings are
true:
• The power switch is turned off.
• The interface cable is un-
plugged from the printer.
C C C C
Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ The removed screws are re-
quired in step
24
K
.
ZKEX750E
D D D D
Pull out the handle of the control-
ler board.
E E E E
Holding the handle, slowly pull
out the controller board.
F F F F
Place the controller board on a flat
surface.
G G G G
The Memory Unit is installed in
the slot shown in the illustration
below.
ZKEX370E
ZKEX720E
ZKEX021E