Smartdevicemonitor For Admin - Ricoh CL1000N User Manual

SmartDeviceMonitor for Admin

A A A A
Run SmartDeviceMonitor for Admin.
B B B B
Click the [Group] menu, point to [Search Device], and select [TCP/IP] or [IPX/SPX]. A list of print-
ers appears.
Note
Select the protocol of the printer you want to change its configuration.
C C C C
On the list, select a printer whose network interface board you want to change its configuration.
D D D D
From the [Tools] menu, select [NIB Setup Tool].
The NIB Setup Tool starts up.
E E E E
Select [Property Sheet], and then click [OK].
TCP/IP
A Click the [General] tab, and then type the device name into the [Device Name] box and com-
ment into the [Comment] box.
• In the [Device Name] box, type the name of the printer within 15 characters. The factory de-
fault name consists of "RNP" and the last 3 bytes of the MAC address on the network inter-
face board. For example, when the MAC address is 00:00:74:62:7D:D5, the factory default
name is "RNP627DD5". No name of 9 characters is permitted if the prefix is "RNP". Also,
when DHCP is selected as an IP address setting, the number of characters is limited to 13
characters.
• In the [Comment] box, type any comment on printers within 31 characters.
Operating Instructions Administrator Reference
138