Configuring The Protocols - Ricoh CL1000N User Manual

Configuring the Protocols

Configuring TCP/IP and IPP for Printing
Follow these instructions to configure the printer and Windows 2000 to use the TCP/IP protocol and IPP.
Configuring the printer
Configure the printer to use the TCP/IP protocol.
• Confirm that the TCP/IP protocol is set to be active. (The factory default is active.)
• Assign an IP address and make other settings required for using the TCP/IP protocol.
Reference
For more information about how to make the above settings, see "Configuring the printer for the
Network", Administrator Reference.
If DHCP is used to assign IP addresses, see "Using DHCP", Administrator Reference.
Note
After setting the IP address, use the ping command to confirm that it has been set correctly.
A
Click [Start], point to [Programs], point to [Accessories], and then click [Command Prompt].
B
Type the following: (Example IP address is 192.168.15.16)
C:> ping 192.168.15.16
If the address has been configured correctly, the following message appears.
Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32
If the address has been configured incorrectly, the following message appears.
Request timed out.
Operating Instructions Client Reference
65