Memory Unit Type C (Sdram Module) - Ricoh AP600N Setup Manual

Memory Unit Type C (SDRAM Module)

Important
❒ Before touching the Memory Unit,
touch something metal to dis-
charge any static electricity. Static
electricity can damage the Memo-
ry Unit.
❒ Do not subject the Memory unit to
physical shocks.
A A A A
Check the contents of the box for
the following items:
• Memory Unit
• Installation Guide
B B B B
Be sure to check the following
points:
• The power switch is turned off.
• The interface cable is un-
plugged from the printer.
Note
❒ If the Duplex Unit is not at-
tached, go to step
C C C C
If the Duplex Unit is attached,
push down the lever on right side
(A A A A ) and pull out the Duplex Unit
until it stops (B B B B ).
D D D D
E E E E
D
.
ZKGX320E
Memory Unit Type C (SDRAM Module)
Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ The removed screws are re-
L
quired in step .
Pull out the handle of the control-
ler board.
2
ZKGX280E
ZKGX370E
25