Ricoh CL1000N User Manual page 481

Configuration
msh> wiconfig parameter
Parameter
mode [ap|adhoc|802.11adhoc]
ssid ID value
channel frequency channel no.
enc [on|off]
Operating Instructions
Value to be configured
You can set infrastructure mode (ap) , 802.11 ad hoc
mode (802.11adhoc) or ad hoc mode (adhoc).
The default is ad hoc mode.
You can set for SSID in infrastructure mode.
The characters that can be used are ASCII 0x20-0x7e
(32 bytes).
A SSID value is set automatically to the nearest access
point if the setting has not been made.
If the setting has not been made for ad hoc mode, the
same value as for infrastructure mode or an "ASSID"
value is set automatically if the setting has not been
made.
You can set the channel.
You can specify from following channel.
•
•
Set the same channel for all the machines you are using.
You can enable or disable the WEP function. To enable
the WEP function, specify [on]; to disable it, specify
[off].
To start the WEP function, enter the correct WEP key.
Administrator Reference
Metric Version :1-13
Inch Version :1-11
256