Configuring Netbeui For Printing - Ricoh CL1000N User Manual

Configuring NetBEUI for Printing

Follow these instructions to configure the network interface board and Windows 2000 to use the Net-
BEUI protocol.
Preparation
To use NetBEUI, use the SmartDeviceMonitor for Client port.
Configuring the printer
Enable SMB to print using NetBEUI (The default is active).
Reference
For more information about how to make the above settings, see
the Network" that comes with this printer.
Configuring a Windows 2000 computer
Follow these steps to configure a Windows 2000 computer to use the NetBEUI protocol.
A A A A
Click [Start] on the taskbar, point to [Settings], and then click [Network and Dial-up Connections].
B B B B
Click [Local Area Connection]. On the [File] menu, click [Properties].
C C C C
Confirm that "NetBEUI Protocol" is selected in the [Components checked are used by this con-
nection:] box under the [General] tab.
Note
If the check box for the NetBEUI protocol is not selected, select the box.
If the NetBEUI protocol is not installed, click [Install] under the [General] tab and install it. For more
information about installing the NetBEUI protocol, see Windows 2000 Help.
Operating Instructions Administrator Reference
p.16 "Configuring the Printer for
26