Ricoh CL1000N User Manual page 596

Configuring NetBEUI for Printing
Follow these instructions to configure the printer and Windows 95/98/Me to use the NetBEUI protocol.
Limitation
To use NetBEUI, use the SmartDeviceMonitor for Client port.
Configuring the printer
Enable SMB to print using NetBEUI (The default is active).
• Confirm that the NetBEUI protocol is set to be active. (The default is active.)
Reference
For more information about how to make the above settings, see "Configuring the printer for the
Network", Administrator Reference.
Configuring a Windows 95/98/Me computer
Install the NetBEUI protocol on the Windows 95/98/Me computer and set it as the default protocol.
A
Open [Control Panel] and double-click the [Network] icon. Confirm that "NetBEUI" is listed in
the [The following network components are installed:] box under the [Configuration] tab.
Note
If the NetBEUI protocol is not installed, click [Add] under the [Configuration] tab and install it.
For more information about installing the NetBEUI protocol, see Windows 95/98/Me Help.
If "NetBEUI ->Dial-Up Adaptor" is listed in the [The following network components are installed:]
box, select it, and then click [Remove] to remove the binding.
B
Set the NetBEUI protocol as the default protocol. Click the [Configuration] tab, select "Net-
BEUI" in the [The following network components are installed:] box, and then click [Properties].
C
Click the [Advanced] tab, select [Set this protocol to be the default protocol], and then click [OK].
D
Click [OK] to close the [Network] dialog box.
E
When the message to restart appears, click [Yes].
Operating Instructions Client Reference
30