Spool Printing - Ricoh CL1000N User Manual

Spool Printing

With Spool Printing, the whole data of a print job is saved in the hard disk drive before printing. To use
this function, set it from the menu. See
Important
Do not turn off the printer or the computer when a print job is being spooled and the Data In indicator
is blinking. If you do, the print job will remain in the hard disk drive and be printed when the printer
is turned on.
Limitation
Spool Printing does not appear unless the optional hard disk drive is installed.
Data that has been received in the protocol other than "diprint", "lpr", "IPP", or "SMB" cannot be
spooled.
With "diprint", spool printing cannot take place using bi-directional communication.
A maximum number of 150 jobs can be spooled.
The capacity of the domain reserved for spool printing is about 1 GB.
When Spool Printing is on, the size of a single print job cannot exceed 500 MB.
When sending spooled print jobs from more than one computer at the same time, up to one diprint
job, 10 LPR jobs, one IPP job, and one SMB job can be spooled. Jobs exceeding the maximum
number cannot be spooled. Wait until the number of spooled print jobs falls below the maximum be-
fore adding jobs.
Note
When "On" is selected, the first print will take time.
With spool printing, the computer is freed from print processing earlier, even when processing a
large amount of data.
Spool jobs stored in the machine can be viewed or deleted using a Web browser.
Operating Instructions
p.186 "System Menu".
Administrator Reference
316