Windows Nt 4.0 Print Server Configuration; Configuring The Protocols; Configuring Tcp/Ip And Ipp For Printing - Ricoh CL2000 Operating Instructions Manual

3. Windows NT 4.0 Print Server Configuration

To use a printer connected to the Ethernet interface, click [SmartDeviceMonitor] or [LPR Port] when in-
stalling the printer driver.
• SmartDeviceMonitor
See p.54 "Configuring the
RPCS Printer Driver", and
• LPR Port
See p.54 "Configuring the
p.65 "Installing the PostScript Printer
Note
If you want to use "LPR Port", "Microsoft TCP/ IP Printing" must be installed. For details, see
Windows NT 4.0 Help.

Configuring the Protocols

Configuring TCP/IP and IPP for Printing

This describes how to configure the network interface board and Windows NT 4.0 to use TCP/IP and
IPP.
Configuring the printer
Configure the printer to use TCP/IP.
• Check TCP/IP is set to active. (The factory default is active.)
• Assign an IP address and make other settings required for TCP/IP.
Operating Instructions
Protocols", p.59 "Installing
p.65 "Installing the PostScript Printer
Protocols", p.60 "Installing the PCL 5c or RPCS Printer
Driver".
Administrator Reference
Software", p.60 "Installing the PCL 5c or
Driver".
54
Driver", and