Ricoh CL2000 Operating Instructions Manual page 407

WINS
Use the wins command to configure the WINS server settings
For more information about WINS server settings, see
Configuration
Use the set command to make WINS active or inactive.
msh> set wins {on|off}|msh> set wins {on|off}
• "on" means active and "off" means inactive.
Viewing setting
The following command displays the WINS server IP address.
msh> wins
Example out put:
wins: primary server 0.0.0.0
Note
If DHCP is used to start from the network, the current WINS server address is displayed. This
address, however, is not displayed if DHCP is not used.
If the IP address obtained from DHCP differs from the WINS IP address, the DHCP address is
the valid address.
Address configuration
Use this command to configure a WINS server IP address.
msh> wins {primary|secondary} IP_address
Note
Use the "primary" to configure a primary WINS server IP address.
Use the "secondary" to configure a secondary WINS server IP address.
Operating Instructions
p.242 "Configuring a WINS
secondary server 0.0.0.0
Administrator Reference
Server".
208