Connecting The Network Interface Cable To The Network - Ricoh CL2000 Operating Instructions Manual

Connecting the Network
Interface Cable to the Network
A A A A
Turn off the power
B B B B
Loop the network interface cable
and attach the ferrite core.
Note
❒ Attach two ferrite cores to the
network interface cable. One of
them must be attached close to
the end of the cable (on the end
closet to the printer). The other
must be attached approximate-
ly 45 cm (18") (A) apart from the
end. Attach each ferrite core
with a loop.
C C C C
Attach the network interface ca-
ble to the jack on the Network In-
terface Unit.
D D D D
Connect the other end of the net-
work interface cable to the net-
work.
E E E E
Turn on the power.
ZHBP913E
ZHBP1470E
Network Interface Board Type 3000
1
38