Ricoh CL2000 Operating Instructions Manual page 411

Changing the Password
Use the passwd command to change the remote maintenance password.
Important
Be sure not to forget or lose the password.
Note
The default factory password is "password".
A A A A
Type "passwd".
msh> passwd
B B B B
Type the current password.
Old password:
C C C C
Type the new password.
New password:
Note
The password must consist of 3 to 8 alphanumeric characters and symbols. Upper and lower
case characters are considered unique. For example, R is different from r.
The password is the same as that used in the configuration of the Network Interface Board using
a Web browse and that used in the NIB Setup Tool. If you change a password from telnet, other
passwords are also changed.
D D D D
Type the new password once again.
Retype new password:
Operating Instructions Administrator Reference
212