Ricoh CL2000 Operating Instructions Manual page 194

D D D D
While holding the handle, pull
out the controller board slowly.
The User Account Enhance Unit is
to be installed to the position
shown in the illustration.
E E E E
Set the User Account Enhance Unit
on the controller board in the di-
rection shown in the illustration.
Confirm that the User Account En-
hance Unit is firmly connected to
the controller board.
F F F F
Align the screw hole of the User
Account Enhance Unit and the
controller board, and then fasten
the User Account Enhance Unit
on the controller board using a
supplied screw.
ZHBP020E
G G G G
Align the controller board to the
top and bottom rails, and then
push in slowly until it stops.
Note
❒ When installing other options
on the controller board, do not
close the controller board, but
go to the steps for installing the
ZHBP130E
option.
Important
❒ The printer may not work prop-
ZHBP140E
erly if the controller board is not
set properly.
User Account Enhance Unit Type B
1
ZHBP150E
ZHBP070E
40