Changing Names And Comments - Ricoh CL2000 Operating Instructions Manual

Changing Names and Comments

You can change printer names and attach comments to help identify printers listed on SmartDevice-
Monitor for Admin.
SmartDeviceMonitor for Admin allows you to change names and comments when TCP/IP or IPX/SPX
is available. You can install SmartDeviceMonitor for Admin from the CD-ROM provided. For more
information about installing SmartDeviceMonitor for Admin, see
tor for Admin".
The following utilities are used to change printer names and comments:
Note
Each of the names, in TCP/IP form (printer name) and NetBEUI form, is changed individually. Com-
ments are, however, common to both protocols.
The factory default name consists of "RNP" and the last 3 bytes of the MAC address on the network
interface board. For example, if the MAC address is 00:00:74:62:7D:D5, the factory default name is
"RNP627DD5". Comments are not configured.
A A A A
Start SmartDeviceMonitor for Admin.
B B B B
Click the [Group] menu, point to [Search Device], and click [TCP/IP] or [IPX/SPX]. A list of print-
ers appears.
Note
Select the protocol of the printer for which you want to change configuration.
C C C C
In the list, select the printer for the network interface board you want to change configuration.
D D D D
On the [Tools] menu, click [NIB Setup Tool].
NIB Setup Tool starts.
E E E E
Click [Property Sheet], and then click [OK].
Operating Instructions Administrator Reference
p.98 "Installing SmartDeviceMoni-
100