Ricoh CL2000 Operating Instructions Manual page 167

Options
❒ Some models have only one
SDRAM Module slot. In that
case, maximum SDRAM capac-
ity is 256 MB.
1
Note
❒ For the controller boards that
have two SDRAM Module slots,
the following combinations are
recommended:
CN2 (back
A A A A )
128 MB
128 MB
128 MB
128 MB
D D D D
Adjust the notch of the Memory
Unit to the slot, and then insert
vertically.
E E E E
Press the Memory Unit down un-
til it clicks into place.
13
Slot
Total
CN3
memory
(front B B B B )
None 128 MB
64 MB 192 MB
128 MB 256 MB
256 MB 384 MB
ZHBP110E
ZHBP120E
F F F F
Align the controller board to the
top and bottom rails, and then
push in slowly until it stops.
Note
❒ When installing other options
on the controller board, do not
close the controller board, but
go to the steps for installing the
option.
Important
❒ The printer may not work prop-
erly if the controller board is not
set properly.
G G G G
Fasten the controller board to the
printer with the two screws that
you removed in step
ZHBP070E
B B B B
.
ZHBP010E