Ricoh CL2000 Operating Instructions Manual page 584

• PostScript 3
\DRIVERS\PS\WIN2K_XP\(Language)\DISK1
G G G G
Click [OK].
A printer model selection dialog box appears.
H H H H
Follow the instructions on the screen.
Note
When installation is complete, the printer with its port directed to "1394_00n" appears on the
[Printers and Faxes] folder. ("n" is the number of printers connected.)
If the printer driver is already installed, the printer icon is automatically added to the [Printers and
Faxes] folder. In this case, installation is not necessary.
Even if the printer driver has already been installed, [Found New Hardware Wizard] may start when
connecting the printer and the computer with the IEEE 1394 interface cable for the first time. In
this case, install the printer driver by following the procedure.
If printing does not work properly after installation, you need to delete the port and reinstall the
printer driver. For more information, see "Printer Does Not Print", Maintenance Guide.
If you do not want to install the printer driver when [Found New Hardware Wizard] starts when using
an operating system that supports SCSI print, inactivate the device by following this procedure:
A
In the [Found New Hardware Wizard] dialog box, check [This wizard helps you install software
for: (Unknown)] is displayed, click [Install from a list or specific location (Advanced)], and then
click [Next>].
B
When [Please choose your search and installation options.] appears, remove all selections
from [Search for the best driver in these locations.], and then click [Next>].
C
If [The wizard could not find the software on your computer for...] appears, click [OK].
D
If the [Cannot Install this Hardware] message appears, select the [Don't prompt again to install
the software] check box, and then click [Finish].
Operating Instructions Client Reference
118