Ricoh CL2000 Operating Instructions Manual page 349

E E E E
Press the { { { { Enter #} } } } key.
One of the following messages appears on the panel display:
WL.LAN Signal
Good
WL.LAN Signal
Fair
WL.LAN Signal
Poor
WL.LAN Signal
Unavailable
Note
If "WL.LAN Signal" is not displayed, "IEEE 802.11b" has not been selected for "LAN Type" in
"Network Setup" of the Host Interface menu. Select "IEEE 802.11b" for "LAN Type", and then
check the "WL.LAN Signal" in the Maintenance menu again.
If "802.11 Ad hoc" or "Ad hoc" in "Comm. Mode" of "IEEE 802.11b" in the Host Interface menu is
selected, you cannot check the signal. Select "Infrastructure", and then check it again.
Every time you press the { { { { Enter #} } } } key, the signal is updated.
The signal is indicated as "Good" if the signal strength is 76-100%, "Fair" if the strength is 41-
75%, "Poor" if the strength is 21-40%, and "Unavailable" if the strength is 0-20%. If the signal is
unstable or unavailable, remove obstacles or move the printer to a place where the signal can
be received.
Using wireless devices or microwave sources near the printer might affect the signal.
Operating Instructions
100%
50%
30%
18%
Administrator Reference
150