Ricoh CL2000 Operating Instructions Manual page 550

Installing the Printer Driver
Note
If [Found New Hardware Wizard] appears every time the computer is started or the cable is connected
with Windows 2000, inactivate the device. If you want to install another printer driver after setting
the "1394_00n" port, select the "1394_00n" port by following the procedure for installing a printer
driver.
When the printer connected via the optional IEEE 1394 interface board is installed properly, the icon
in the printer folder changes depending on whether the cable is attached or not.
A A A A
Connect the printer and computer using the IEEE 1394 interface cable.
B B B B
In the [Found New Hardware Wizard] dialog box, click [Next>].
C C C C
When the [This wizard will complete the installation for this Device: (Unknown)] message appears,
click [Search for a suitable driver for my device (recommended)], and then click [Next>].
D D D D
When the [Locate Driver Files] message appears, click [Specify a location], and then click [Next>].
E E E E
Hold down the left { { { { SHIFT} } } } key, and then insert the CD-ROM into the CD-ROM drive.
Keep the left { { { { SHIFT} } } } key held down until the computer has finished accessing the CD-ROM.
If the Auto Run program starts, click [Cancel], and then click [Exit].
F F F F
Click [Browse].
G G G G
Select the printer driver you want to use. The following are locations on the CD-ROM where
printer drivers are stored:
• RPCS
\DRIVERS\RPCS\WIN2K_XP\(Language)\DISK1
Operating Instructions Client Reference
84