Verifying The Plc Programs - Mitsubishi Electric MELDAS C6 Programming Manual

Hide thumbs Also See for MELDAS C6:

Table of Contents

1. PLC Development Environment Using GX Developer

1.3.7 Verifying the PLC Programs

The following indicates how to verify ladders between the CNC and GX Developer.

(1) Operation procedure

Perform the following operation from GX Developer to start the operation screen.

[Online] → [Verify with PLC]

On the following screen, choose the ladder files to be verified with the [File selection] tab, and click

[Verify source] : GX Developer side

(Note) As [Target memory], the fitted memory is valid.

Do not set the other tab ([Program], [Device data]) than [File selection].

If verification mismatches occur, the following mismatch screen appears. Double-click the mismatch

to display the corresponding part of the GX Developer side file.

1.3 Developing PLC Programs

[Verify dest] : CNC side

GX Developer side

CNC controller side

Get other manuals https://www.bkmanuals.com